Gwinstek GDS-820 Série Manuel D'utilisation page 5

Oscilloscopes numériques à mémoire Série GDS-820/840
NOTE: This lead/appliance must only be wired by competent persons
WARNING: THIS APPLIANCE MUST BE EARTHED
IMPORTANT: The wires in this lead are colored in accordance with the following code:
Green/ Yellow: Earth
Blue: Neutral
Brown: Live(Phase)
As the colors of the wires in main leads may not correspond with the colors identified in
your plug/appliance, proceed as follows:
The wire which is colored Green & Yellow must be connected to the Earth terminal
marked with the letter E or by the earth symbol
The wire which is colored Blue must be connected to the terminal which is marked with the
letter N or colored Blue or Black. The wire which is colored Brown must be connected to
the terminal marked with the letter L or P or colored Brown or Red.
If in doubt, consult the instructions provided with the equipment or contact the supplier.
This cable/appliance should be protected by a suitably rated and approved HBC mains fuse:
refer to the rating information on the equipment and/or user instructions for details. As a
guide, cable of 0.75mm² should be protected by a 3A or 5A fuse. Larger conductors would
normally require 13A types, depending on the connection method used.
Any molded mains connector that requires removal /replacement must be destroyed by
removal of any fuse & fuse carrier and disposed of immediately, as a plug with bared wires
is hazardous if engaged in live socket. Any re-wiring must be carried out in accordance
with the information detailed on this label.
POUR L'ANGLETERRE UNIQUEMENT.
FOR UNITED KINGDOM ONLY
E5
or colored Green or Green & Yellow.