EN
Meaning of symbols
stallation
Kontrolle
Check
r
Richtig
Correct installation
hrmontage
Falsch
Incorrect installation
Verweis anderes
Dokument
Cross reference to other
products or documentation
sch
Fliesenleger
Large and small format tile work
asserhahn
Klebemontage
Adhesive mounting
Area of application
The Minimum tray support is a mounting system that
ensures the installation of our shower trays and areas is
completed easily and quickly.
It is designed for the following products:
– BetteFloor
– BetteFloor Side
– BetteUltra
Safety information
– The safety, function and integrity of the product can only be
guaranteed if the information provided here is observed.
Failure to do so may result in injury or damage to persons
or property. The manufacturer is not liable for any damage
resulting from a failure to observe the instructions.
– It is essential that you follow the instructions given in the
installation guide in order to prevent installation errors and
damage to the product.
– Please observe the general safety and accident prevention
regulations in addition to the information provided in these
instructions.
4
Important information -
please note
About this guide
– This installation guide must be available for the entire
duration of the installation process. If the installation is to be
carried out by several individuals (e.g. fitter, tiler etc.), then the
installation guide must be passed on as appropriate.
– The installation may be carried out without a wall side or
against one, two or three wall sides. The illustrations show
the installation of the Minimum tray support for the corner
installation of a shower tray.
– The dimensions are given in mm (millimetres).
– The illustrations are not true to scale.
– Subject to technical changes.
Installation information
– Only to be installed by qualified specialists.
– Handle the product with the greatest care in order to prevent
damage. Rings and other items that could damage the
product must be removed before installation.
– Use a solvent-free adhesive to prevent damage to the
Minimum tray support.
– The adhesion points must be clean, dry and free from grease.
– The Minimum tray support must be positioned precisely and
neatly.
– The Minimum tray support must be pressed firmly along the
adhesive points to prevent it from coming away and to avoid
glue accumulations.
– All large and small format tiling work must be carried out to
DIN 18157.