Assembly / Operation - WAKÜ 100 Manuel D'utilisation

8

5. Assembly / Operation

Set-up as a freestanding ladder:
Stand the collapsed ladder
upright in front of you.
Pull out all four side spring
bolts and rest them on the
edge.
Pull out the inner section to
the desired rung height and
hold in place with one hand.
Engage the spring bolts into the rungs with the other hand.
Pull out the ladder to its maximum opening angle.
Putting away the freestanding ladder:
Fold together the ladder, hold the inner section with one hand,
release all four spring bolts, push in the inner section, engage the
spring bolts.
Converting the freestanding ladder into a single ladder:
Pull out the locking pins on
both hinges as far as they
will go.
Open out the ladder to
180° making sure that the
locking pins are fully enga-
ged in the hinge.
Position the ladder at a wor-
king angle of approx. 70°. Ensure that contact surfaces are stable
and that the ladder will not slip.
PLEASE NOTE: All four height adjusters and the two hinges must
be correctly engaged. Do not use the inner section of the ladder
without the conical outer sections. Maximum load 150 kg.
5.1 General safety instructions
Read the instructions in full. Addition information
1.
on ladders is available on the internet.
Check after delivery and before each use if this
2.
is damaged. Never use a damaged ladder.
3.
Maximum load.
WAKÜ-Telescopic ladder • Instructions for use
Assembly variants (main representations):
• Free-standing ladders in various positions
• Single ladders in various positions
5.1 General safety instructions
4.
5.
6.
Set up the ladder on flat, level and firm base.
Avoid leaning out sideways.
Remove contamination from the floor.