Changing The Bulb; Cleaning And Storage - Eurotops CD-026M-1 Mode D'emploi

Changing the Bulb

ATTENTION!
❐ Please always grab the base of the bulb (as shown in fi gure).
❐ Don't get into direct contact with the bulb by changing. Always use handkerchiefs or gloves.
Otherwise the lifetime of the tube lights will be decreased.
❐ Let the bulb always cool down completely before changing it.
❐ Always remove the plug from the mains socket before changing the bulb.
❐ Do only use bulbs, which correspond to the technical data (see chapter "Technical Data").
To reorder bulbs, visit www.service-shopping.de or contact the customer service de-
partment.
1. Remove the plug from the mains socket.
2. Turn the head of lamp so you can insert the bulb without problems.
3. Pull the old bulb carefully out of the lamp holder and take it off the mounting.
Similar to this shown

Cleaning and Storage

ATTENTION!
❐ Remove the plug from the mains socket before cleaning the lamp.
❐ Let the lamp always cool down completely before cleaning it or putting it away.
❐ Do not use corrosive or abrasive cleaning agents or cleaning pads to clean the lamp. These
could damage the surface.
• If necessary, clean the lamp with a soft, dry cloth.
• Store the lamp on a dry, clean place, which is inaccessible to children.
00852_DE-GB-FR-NL_V5.indb 13 00852_DE-GB-FR-NL_V5.indb 13
4. Insert the new bulb into the lamp holder and press it care-
fully, as illustrated, into the mounting. It has to snap in acous-
tically.
13
26.09.2013 10:38:09 26.09.2013 10:38:09