myaudioart ma5 Mode D'emploi page 28

Removing and replacing the fabric covering
You can remove the fabric covering in a few simple steps. This may be necessary in
order to adjust the input sensitivity or connect an AirPort Express.
You can also change the fabric covering to use a different motif.
Risk of damage!
ATTENTION
Only use original AudioArt fabric coverings. Other fabric
coverings can cause damage to the system, for example
through overheating.
To facilitate removing the covering, an assembly tool is included in the delivery scope
of the system.
Removing the fabric covering
– Run one finger over the back of the frame on the side of the system where the LEDs
are. About one hand's breadth away from the corner you will be able to feel a small
hole (1) in the frame.
– Introduce the straight end (2) of the assembly tool in the hole from the rear and pull
the bent end (3) of the assembly tool forward. The fabric covering is pushed out of
the frame.
– Grasp the slightly protruding fabric covering gently between thumb and index finger
and slowly pull it out of the frame.
– Pull the fabric covering completely out of the frame and put it on a smooth surface
without folding or bending it.
– Carefully separate the fleece and slowly remove it from the hook and loop strips.
Put it down without folding or bending it.
54
2
1
3
User Manual
Replacing the fabric covering
First place the fleece and then the fabric covering into the frame.
– Straighten the fleece on the top edge of the frame and press it at one corner onto
the hook and loop strip on the frame.
– Slightly smoothen the fleece on the opposite corner and press it onto the hook and
loop strip at that corner.
– Press the fleece on all the hook and loop strips one after another.
– Insert the rubber strips (1) of the fabric covering into one of the upper corners of the
frame (2). Make sure that the print is on the outside.
1
– Insert the rubber strips into the other upper corner of the frame
– Insert the rubber strips into the two bottom corners of the frame.
– Slide the rubber strips along the edges inside the frame until the fabric cover lies
smoothly at every point.
User Manual
2
55