Timer Functions; Double Channel Number; Switching Between Single And Double Channel Number - Conrad FS20 S20-3 Notice D'emploi

The transmitter channels are already set to the same addresses (see Chapter 11 b) and must
be changed if required, for example if you wish to use a large comprehensive FS20 radio
switching system with several receivers/transmitters.

Please note the example in Chapter 11 d).
c) Timer Functions
In order to programme the timer function of a receiver, the allocated button pair (e.g. for channel
1 the buttons " 1 " and "
(1s to 5s).
This command starts the timer programming and also ends it when you are finished.

The actual programming of the timer is to be carried out in accordance with the
respective operating instructions of the receiver.
d) Double Channel Number
The remote control can be used as 10 channel (basic setting, two buttons per channel e.g. for
channel 1: buttons "
allocated one button, not a button pair e.g. for channel 1: button "
2
" " etc.).

• Switching Between Single and Double Channel Number

The double channel number (20 individual switching channels) is set by pressing the "
3
and " " buttons (see chapter 8) together for at least 5 seconds. The control light LED is lit
shortly as confirmation of the setting.
The single channel number (10 switching channels with 2 buttons each) is set by pressing
1 4
the " " and "
as confirmation of the setting.

Please note:
The operation and programming for the double channel number setting differs
from normal operation!
30
2 ") must be pressed together at the same time for one to five seconds
1 2
" and " ") as well as a 20 channel remote control (each channel is
" buttons together for at least 5 seconds. The control light LED is lit shortly
1
" and for channel 2: Button
2
"