Schwaiger MPLED 3 Mode D'emploi page 5

5. Installation
360°Rotating Sensor Night Light can be
used after installing the batteries.
1
Remove the adhesive side of the 3M tape,
Adhere to the circular base of the product,
as shown in Picture 1.
3
Remove the other side of the 3M adhesive
Tape and attach it to the plane where
required, as shown in Picture 3.
5. Technical Data
Light source
Power source
Mode
Sensor
Detection Range
Detection Angle
Working temperature
Material body
Product size
Weight body:
Disclaimer
Schwaiger GmbH does not accept any liability or warranty for damages that are sustained
due to improper installation or mounting, improper use of the product or non-compliance
with the safety instructions.
Disposal
Do not dispose of batteries or electric and electronic devices in the normal household
waste. The consumer is legally obliged to return electrical and electronic devices,
and batteries that are at the end of their useful life to the point of sale or public
collection points that have been set up for this purpose. Legislation in the country of
use stipulate the specific requirements regarding disposal. The symbol on the product, user
guide or the packaging indicates this legal requirement.
EC declaration of conformity
This product is provided with the marking required by the applicable directives. The CE
marking is Schwaiger GmbH's declaration that this product meets the basic requirements
and directives in European provisions.
5 LEDs front on, 6 LEDs back on
3 x AAA Battery (Batteries included)
Lighting On; AUTO (motion-sensing); Off and front- / backlight
Passive Infrared (PIR)
3-5 meters
Up to approx. 100° (horizontal) & 50° (vertical)
-10 C° bis 40 C°
ABS
63 x 90 mm dia. (incl. bracket)
104 g
USER MANUAL
BEDIENUNGSANLEITUNG
2
Insert the lamp rotaional holder into the
base plate, as shown in Picture 2.
4
Stick the product onto the lamp rotational
base for use, as shown in Picture 4. The
magnet on the bottom side of the lamp
holds the lamp in the chosen position.
OPEN
5