Publicité
Les langues disponibles
Les langues disponibles
Connectors (3)
Setting up
* The picture quality is much better if you use the Y/C (S-video) output (13) rather then
the composite video output (12). Especially with typed material in black and white. When
using the composite video output please make sure that a dedicated video cable (75
RCA plugs is used, and not an audio cable with RCA plugs !!!
1. Pull the arm upwards using the special pull ring (8)
2. Turn the video camera head (1) and point it at the working surface
3. Connect the power adaptor to the DC-input (14).
4. Connect a TV-monitor, a video projector or a video recorder to
the video output (12) or the Y/C-output (13)*
5. Switch on the Visualizer with the power switch (5)
Power-on Preset
The power-on preset is automatically activated when switching on
the unit. The settings are: Zoom size approx. 20 x 15 cm (A5),
Autofocus on, Autoiris on, Image on
ENGLISH
Check which model you have!
This is a combined manual for the
Visualizers VZ-7D, VZ-5D and VZ-5F.
Pages 4-5 and 8 apply for all units.
The additional features of VZ-7D (5D)
are described on pages 6-7 and 24.
1 Video camera head
2 Light
3 Connectors (on the back, see below)
4 Working surface
5 Power on/off key
6 Light key
7 Close up lens for camera
8 Pull ring
9 Auto focus on/off key
(a light above this key shows
that the auto focus is on)
10 Zoom keys
11 Slide drawer (VZ-7D only)
12 Composite video output (VBS)
13 Y/C (S-video) output
14 DC input (12 V)
15 DC output for lightbox
16 Serial control input RS232 (VZ-7D only)
17 DIP switches (VZ-7D only) - see detailed
list on last page - experienced user only
4
W)
with
Publicité
