Inserting And Changing Screwdriver Bits - easymaxx HL-S36-30L Mode D'emploi

4. Charge up the battery of the device in good time so that the device can operate on
full power.

Inserting and Changing Screwdriver Bits

You can use the cordless screwdriver both with and without the extension for the
screwdriver bits.
1. Move the rotation direction changeover switch to the middle position to prevent any
accidental start-up.
The cordless screwdriver can also be used without the extension for the
screwdriver attachments. To do this, plug the screwdriver attachment directly
into the bit receptacle.
2. Move the adjusting wheel on the chuck until the required
screwdriver bit is exposed.
3. Remove the screwdriver bit.
For an easy removal of the screwdriver bit, pull back the
adjusting wheel (in the direction shown in the picture).
4. Place the extension for the screwdriver bits into the bit
receptacle of the device.
5. Place the screwdriver attachment into the extension for
the screwdriver bits.
24