Care And Maintenance; Cleaning The Washer-Dryer; Cleaning The Detergent Dispenser Drawer; Caring For The Door And Drum Of Your Appliance - Hotpoint WDD 9640 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 13

Care and maintenance

Cutting off the water and electricity
GB
supplies
• Turn off the water tap after every wash cycle. This will limit
wear on the hydraulic system inside the washer-dryer and
help to prevent leaks.
• Unplug the washer-dryer when cleaning it and during all
maintenance work.

Cleaning the washer-dryer

• The outer parts and rubber components of the applian-
ce can be cleaned using a soft cloth soaked in lukewarm
soapy water. Do not use solvents or abrasives.
• The washer-dryer has a "Auto Clean" programme for its
internal parts that must be run with no load in the drum.
For maximum performance you may want to use either
the detergent (i.e. a quantity 10% the quantity specified
for lightly-soiled garments) or special additives to clean the
washer-dryer. We recommend running a cleaning program-
me every 40 wash cycles.
To start the programme press buttons A and B simulta-
neously for 5 seconds (see figure).
The programme will start automatically and will last appro-
ximately 70 minutes. To stop the cycle press the START/
PAUSE button.
A
B

Cleaning the detergent dispenser drawer

10
Remove the dispenser by
1
raising it and pulling it out
(see figure).
Wash it under running wa-
ter; this operation should be
repeated frequently.
2
Caring for the door and drum of your
appliance
• Always leave the porthole door ajar in order to prevent
unpleasant odours from forming.

Cleaning the pump

The washer-dryer is fitted with a self-cleaning pump which
does not require any maintenance. Sometimes, small items
(such as coins or buttons) may fall into the pre-chamber
which protects the pump, situated in its bottom part.
!
Make sure the wash cycle has finished and unplug the
appliance.
To access the pre-chamber:
3. clean the inside thoroughly;
4. screw the lid back on;
5. reposition the panel, making sure the hooks are securely
in place before you push it onto the appliance.

Checking the water inlet hose

Check the inlet hose at least once a year. If there are any
cracks, it should be replaced immediately: during the wash
cycles, water pressure is very strong and a cracked hose
could easily split open.
!
Never use second-hand hoses.
1. using a screwdriver,
remove the cover panel on
the lower front part of the
washer-dryer (see figure);
2. unscrew the lid by rota-
ting it anti-clockwise (see
figure): a little water may
trickle out. This is perfectly
normal;

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Wdd 9640b

Table des Matières