Bradex 962 Instructions D'utilisation page 3

Recommended Blocking:
Wood double stud blocking is necessary. Contact an architect and building official
to make sure the blocking is adequate and complies with building codes (Fig. a.).
Contact an architect or building contractor to make sure the blocking is adequate
and complies with building codes.
For A. D. A. compliance, top of lower double stud should be 30" (762 mm)
from the floor.
1. Slide changer into blocking area and mark mounting hole location
on blocking studs.
HINT: This may require 2 additional people to help hold changer
in position while you are marking the locations.
2. Use a power drill with a 3/16" bit and drill six (6) pilot holes in
the blocking studs.
3. Shim changer for a snug fit.
4. Align holes in changer with drilled holes and secure using the wood
screws. Wood screws have been provided and are for wood only (Fig. b).
NOTE: It is installers responsibility to provide correct fastereners
for other substrates.
5. Ensure all six (6) screws are tight.
OPERATION:
Rotate base downward. Place infant on top of the changing surface. Use restraint
system as described below. After child has been changed, remove restraint system
and rotate base back up against the wall.
USE OF RESTRAINT SYSTEM:
Place child so restraint strap is located at abdomen. Rotate top of buckle upward and insert strap
in buckle. Pull strap through buckle until snug against infant. Rotate top of buckle downward to lock
the strap into place. Slide red locking tab over top of buckle (Fig. c). Reverse steps to loosen strap.
MAINTENANCE AND CLEANING:
Check all hardware and components monthly or as required to ensure hardware is tight and there
are no missing or damaged components. Take unit out of service if any component is missing or
damaged and contact your authorized dealer to order replacement parts. Do not substitute parts.
Clean by using a damp cloth with mild soap or mild multi-purpose cleaner. Do not use and strong
chemical cleaners or cleaning agents that may be hazardous to children.
•
Adding excessive weight such as parcels, packages, or accessories to the unit or to the bag hooks that exceed the total
weight limit of 50 pounds (22.7 kg) may cause the unit to be unstable or may cause a hazardous unstable condition to
exist.
INSTALLATION
WARNING
2
TOP VIEW
35 5/8"
1" (905 mm)
(25.4 mm)
FRONT VIEW
35 5/8" (905 mm)
Rough-in
Double Stud
Double Stud
Fig. a
Recess
Mounting
Holes
Recess
Mounting
Holes
Top Of
Buckle
3 7/8"
(98.4 mm)
19 5/8"
(499 mm)
Rough-in
Recess
Mounting
Holes
Fig. b
Locking
Tab
Fig. c