Quick Guide For Menu Operation - Sansui SLEDVD198 Guide D'utilisation

DISPLAY
Press DISPLAY to display the current information on
the screen.
When the TV receives a digital signal, the digital
information will appear.
62-1 HDTV Moving Picture1
CH-1 TV-MA
Digital Air
No Program Information is available
Full
1080i
• Channel number
• Channel label (if preset)
• V-Chip rating
• Sleep timer
• Program guide
• Resolution
When the TV receives an analog signal, the analog
information will appear.
14
G
Analog Cable
Mono
Full
480i
• Channel number
• V-Chip rating
• Sleep timer
• Audio information
(Stereo, SAP or Mono)
Press DISPLAY again to clear the call display.
NOTE:
• After a few seconds, DISPLAY screen will return to
normal TV-operation automatically.
RECALL
This button allows you to go back to the last channel
selected by pressing RECALL. Press RECALL again to
return to the last channel you were watching.
MUTE
Press MUTE to switch off the sound. The TV's sound
will be silenced and "Mute" will appear on the screen.
The sound can be switched back on by pressing this
button again or the VOL + or –.
SLEEP
To set the TV to turn off after a preset amount of time,
press SLEEP on the remote control. The clock will
count up 10 minutes for each press of the SLEEP but-
ton (Off, 0h 10m, 0h 20m, ..., 2h 0m). After the sleep
time is programmed, the display will appear briefly
every ten minutes to remind you that the sleep timer
is operating. To confirm the sleep timer setting, press
SLEEP and the remaining time will be displayed for a
few seconds. To cancel the sleep timer, press SLEEP
repeatedly until the display turns to Off.
16
Sleep Timer
Off
English
• Station name
• Broadcast program name
• Signal type
• Audio language
• Picture size
Sleep Timer
Off
• Channel label (if preset)
• Signal type
• Picture size
• Resolution
Quick guide for menu
operation
Call menu and for example: Select Language.
1
Press INPUT SELECT to select TV mode.
2
Press MENU. The TV menu screen will appear.
Main Menu
Picture >>
Audio
Channel
Lock
Setup
3 : Select ENTER:Set
Press ▲ or ▼ to select "Setup", then press ▶ or
ENTER.
4
Press ▲ or ▼ to select "Language", then press ◀
or ▶ to select the desired language.
...on the following pages the menu can be called
in the same way as here.
5
Press EXIT to return to the normal screen.
NOTE:
• If no buttons are pressed for more than about 60
seconds, the menu screen will return to normal
operation automatically.