YORKVILLE Paraline Série Manuel D'installation page 6

PSA1FRAMEKIT on the upper-most enclosure. The cross-members attach to the front and rear
of the 10-point mounting hole PSA1FRAMEKIT side brackets. Make sure the "lip" of the cross-
members are facing inwards, towards each other as shown in the image below. Use two bolts
and hex nuts per corner (as supplied).
of two ½-inch shackles (Crosby part #1017494)
mounted on any of the 10 pickup points along the PSA1FRAMEKIT's bumper. The pickup point cho-
sen
you will also use the 4
8. Reinstall Amplifier Modules
When the whole array is assembled correctly the PSA1 amplifier modules should be rein-
stalled. Connect the amplifier/speaker connectors carefully and refit each module in the cavi-
ties using the original screws.
4
To complete the assembly attach the two supplied painted cross-members to the
Lip
When cross-members have been successfully attached to complete the bumper bar, a
must correspond to one on the other side (ex. If you choose the 4
pickup point on the right side).
th
must be used for each array. The shackles can be
pickup point on the left side,
th
minimum