purline PLC2000 Manuel D'utilisation page 11

entered. The degree of humidity initially displayed is
60%. Three seconds later, the display will indicate
the ambient humidity.
3. Press on the "UP" or "DOWN" button to enter the
desired control point. If the ambient relative humidity
is lower than 3% of the ambient degree, the device
will turn on. If the ambient relative humidity is
higher than 3% of the ambient degree, the device will
turn off.
4. If the control point is lower than 30%, the device
will continue to dehumidify and the display will show
"CO".
On/Off
When the device is on, press on "ON/OFF" to turn the
device off. The light indicators will turn off.
.
Note
1) When the control point is higher than the ambient
humidity, the device will not operate.
2) In the dehumidification mode, when the
compressor is active and the fan turns, they must
operate for at least 3 minutes. Do not try to restart
the compressor again for 3 minutes after the
device has been turned off.
3) When used in a room with a lower temperature,
the device automatically detects the defrosting
operations. In the defrosting mode, the light
indicator turns on, the fan continues to work, but
the compressor automatically stops.
21
4) If you press on the "Memory" button, the internal
recorder will detect the ambient humidity, even
when the device is turned off.
5) The display indicates humidity from 30% to 90%.
6) Carefully press on the various buttons so as not to
damage them.
7) Clean the dehumidifier with caution, as the
humidity sensor is very fragile. Have the device
repaired or replaced if it no longer works.
8) When the dehumidifier is not in use, turn it off
and unplug it.
DEHUMIDIFIER MAINTENANCE
Turn the device off, then unplug it before cleaning.
Because of the accumulation of dust, the air "grill" must be
cleaned regularly, at least once per month. If necessary,
clean it once per week or more often if required. This is
essential for the dehumidifier to operate properly.
Cleaning the Air Filter
Use either a vacuum cleaner (cautiously) or soak the air filter
in warm water at approximately 40° with a non-abrasive
detergent, and clean it with a sponge, then rinse it.
.
Note:
To avoid any deformation, the air filter must not be
exposed to any source of heat.
- Before plugging the device in again, properly
return the air filter to its place and re-screw the
front grill..
22