Publicité
CONTENU DE LA LIVRAISON | STRUCTURE DE L'APPAREIL
Contenu du batterie SC GS Baby
1x Clearomiseur GS Baby
2x Résistance GS Air Organic Cotton 0,75 Ohm | DL
1x Manuel d'utilisation
1x Carte d'information
Tête d'atomiseur GS Air
Airflow Control
Base d'atomiseur
Composante conduit d'air
UTILISATION DE L'APPAREIL
Remarques sur la mise en service
Avant la première utilisation, déposez impérativement quelques gouttes de votre liquide sur la tête
du vapoteur (head) et, après l'installation, laissez-la reposer environ 15 minutes dans le réservoir
rempli de liquide avant de vapoter. Ne nettoyez pas la tête du vapoteur à l'eau. En cas de besoin,
essuyez-la seulement avec un chiffon sec. Étant donné que les têtes de vapoteur sont des pièces
d'usure, elles doivent être remplacées régulièrement.
Consignes de nettoyage
Pour le nettoyage de l'appareil, utilisez un chiffon sec ou un coton-tige.
Vapotage
Pendant que vous maintenez enfoncée la touche d'allumage de votre batterie, inhalez la vapeur
lentement et en continu via l'embout de votre clearomiseur.
Régler l'alimentation d'air
En tournant légèrement la bague de contrôle de débit d'air à la base de la tête de l'atomiseur, vous
augmentez ou réduisez le débit d'air selon vos préférences personnelles. Plus le débit d'air est élevé
(donc plus les fentes de passage d'air sont ouvertes), plus la résistance à l'aspiration diminue. Lors-
que vous vapotez, veillez en particulier à ce qu'il y ait un débit d'air suffisant au niveau du Subohm.
Changement de l'embout
L'embout est enfiché sur le capuchon du clearomiseur. Il peut être enlevé en le tirant légèrement et
replacé en le poussant délicatement. L'embout peut être nettoyé avec de l'eau chaude. Avant la mise
en place, veillez à ce qu'il soit complètement sec.
Remplissage du liquide
1. Dévissez la partie supérieure située en dessous de l'embou-
chure dans le sens antihoraire du réservoir.
2. Remplissez le clearomiseur de liquide via l'ouverture de
remplissage. Veillez impérativement à ce que le liquide ne
pénètre pas dans le canal d'air médian.
3. Pour fermer, revisser la partie supérieure sur le réservoir,
tout en appuyant sur le composant en le tournant vers le
bas. Assurez-vous que le liquide ne peut pas sortir.
Changement de la tête d'atomiseur
1. Retirez le clearomiseur de la batterie / du box de votre cigarette électronique.
2. Tandis que l'embout pointe vers le sol, détachez les composants du base d'atomiseur du
réservoir en verre en tournant dans le sens antihoraire.
3. Dévissez la tête usagée du vapoteur et remplacez-la par une nouvelle. Déposez quelques
gouttes de liquide sur la bobine de la nouvelle tête de vapoteur et attendez qu'elle se gorge
de liquide avant d'utiliser l'appareil.
4. Reconnectez toutes les pièces et veillez à ce que le liquide ne puisse pas se renverser et/ou sortir.
5. Ensuite, connectez à nouveau le clearomiseur à la batterie / le box.
DONNÉES CLÉS ET CARACTÉRISTIQUES DE PERFORMANCE
Caractéristiques de performance du clearomiseur GS Baby
Volume du réservoir
2 ml
Diamètre
16,5 mm
Hauteur (avec embout)
57 mm
Matière
Inox et verre
Type de filetage
510
Features
Remplissage par le haut (système top filling)
Airflow Control
Têtes de vapoteur adaptées
Têtes d'atomiseur de la série SC GS Air
Convient uniquement à une utilisation avec une batterie / un box résistant aux courants
de forte intensité !
SC – GARANTIE ET SERVICE APRÈS-VENTE
Garantie et service après-vente
Si le produit ne fonctionne pas ou est défectueux, veuillez contacter le revendeur spécialisé auprès
duquel vous avez acheté votre appareil. Si vous avez des questions concernant le fonctionnement et
l'utilisation, merci de contacter notre service client.
N'utilisez en aucun cas l'appareil en combinaison avec des produits d'autres fabricants et unique-
ment avec les produits SC compatibles. Nous attirons expressément votre attention sur le fait que
nous déclinerons toute responsabilité en cas de dommages dus à une utilisation inappropriée de ce
produit, et qu'alors toute garantie deviendrait caduque.
SC – CONTACT
Contact de SC
InnoCigs GmbH & Co. KG
Stahltwiete 23
22761 Hambourg | ALLEMAGNE
Téléphone :
+49 (0)40 22 86 729 0
Fax :
+49 (0)40 22 86 729 99
E-mail :
service@innocigs.com
ENGLISH
SC GS BABY – SMART DEVICE WITH A TANK VOLUME OF 2 ML
Instructions for the User
Thank you for choosing SC – an InnoCigs brand! We place great value on high quality and safety
standards across our entire range. We hope you enjoy vaping with your new e-cigarette product!
Read the usage instructions carefully before use in order to ensure correct use of the device.
Use only original and/or recommended products in combination with this product. The manufac-
turer shall not provide any service and/or warranty when non-recommended products are used
together with this product.
Should you have questions or need more information about your e-cigarette product,
please contact your dealer or visit our website at www.innocigs.com.
NOTES & PRECAUTIONS
Persons under 18 years, pregnant women, nursing mothers and people with cardiovascular
disease should not use this product. Not recommended for non-smokers. Please keep out of the
reach of children.
This product must not be used by minors.
This product must be kept away from children.
This product must not be used by pregnant or nursing women.
Electronic goods and batteries should not be disposed with normal household waste! Please dispose of
used electronic goods and batteries – as required by law – at a municipal collection location, so that raw
materials and potentially harmful substances can be properly removed and recycled.
This product complies with EU require-ments on technical goods and may be sold throughout the
European Union.
Embout
Top Cap
Réservoir de verre
Dimension de l'ouverture
du réservoir de liquide
User Instructions
1. If the device has been dropped, please check if any components have come loose, whether
there is liquid leakage, or whether there is any defect on your mouthpiece. If there are no signs of
damage upon visual inspection of the product, you can continue using the device. For hygienic
reasons, please wipe the mouthpiece with a cloth before reusing.
2. The device should not be used if there are cracks or deformations in the material or a defective
part needs to be replaced. Never attempt to repair the device on your own if a defect occurs.
3. The device should not be used when the e-liquid in the clearomizer tank is empty or almost
empty. The same applies if you experience a change in the taste. Please fill the Clearomizer tank
with fresh e-liquid and replace the head before you continue to use the e-cigarette. Because
atomizer heads are wearing parts, they must be changed regularly.
4. Never store the device in rooms with extremely high temperatures or in rooms with extremely
high humidity. Avoid long periods of direct sunlight.
5. The recommended temperature range for charging is 5°C to 45°C and for using the device
is -10°C to 60°C.
6. If e-liquid comes in contact with your skin, wipe it off as soon as possible and wash the area
of contact.
7. If e-liquid is swallowed, contact your local poison control center. The Poison Emergency
Hotline of the Charité University Hospital Berlin can be reached day and night by phone at
+49 (0)30 - 19 240. In Austria, you can reach the 24h hotline of the Vienna Poison Informati-
on Center by phone at +43 (0)1 - 406 43 43. In France, please contact one of the local poison
control centers. In case of emergency, immediately contact local emergency officials.
8. Nicotine can increase the heart rate and/or blood pressure. Nicotine can cause nausea, dizziness
and/or stomach pain. If you notice any undesirable side effects, discontinue use and consult a
physician.
9. Please comply with all local laws when using this e-cigarette product.
10. The product must not be placed in the hands of children or adolescents.
Warning
This e-cigarette product can be used with nicotine-containing e-liquid. Nicotine is a highly
addictive substance.
General Information about Puffing Techniques while Vaping
When vaping, a distinction is made between two puffing techniques:
Moderate Vaping (Mouth-to-Lung)
The vapor from an e-cigarette is first collected in the oral cavity for the entire duration of the puff
and then inhaled into the lungs. This puffing technique is referred to as moderate, mouth-to-lung
vaping and is similar to smoking. To achieve this, there must be a noticeable resistance when
puffing on the e-cigarette. Evaporator heads that support this puffing technique in the moderate
range (resistance usually > 1 ohm) are often referred to as MTL (mouth to lung) heads. (Other
abbreviations include ML and M2L.)
Sub-Ohm Vaping (Direct Lung Inhalation)
While puffing, the vapor of an e-cigarette is directly inhaled into the lungs. This puffing technique
is referred to as sub-ohm vaping with direct lung inhalation. To achieve this, there must be low
puffing resistance and a strong air supply to the evaporator head. Both have a positive effect on
producing large quantities of vapor. Evaporator heads that support this puffing technique in the
sub-ohm range (resistance usually < 1 ohm) are often referred to as DL (direct lung) heads. (other
abbreviations include DTL and D2L)
CONTENTS | DESIGN OF THE DEVICE
Contents SC GS Baby Clearomizer
1x GS Baby Clearomizer
2x GS Air Head Organic Cotton 0.75 Ohm | DL
1x User Manual
1x Info Card
Airflow Control
Head Base
USING THE DEVICE
4
mm
Notes for Commissioning
Prior to first use, drip a few drops of your e-liquid on the atomizer head and let it sit before
vaping. Please take several puffs without activating the atomizer and leave the atomizer head
sit for 15 minutes in the e-liquid filled tank before use. Don't clean atomizer heads with water.
Because atomizer coils are wearing parts, they must be changed regularly.
Note for Cleaning
Use a dry cloth or cotton swab to clean the clearomizer.
Vaping
While holding the fire button of your e-cigarette, inhale the vapor slowly and continuously through
the mouthpiece of your clearomizer. Release the fire button while exhaling the vapor.
Adjusting the Air Supply
There is a airflow control ring located on the head base of the device. It can be adjusted by slightly
turning and is adaptable to your vapor preferences. The more air flows through the device (the more
the slots are open), the lower is the drawing resistance. Pay particular attention to a sufficient air
supply during sub-ohm vaping.
Changing the Mouthpiece
The mouthpiece is placed on the top cap of the clearomizer. It can be removed by gently pulling
up and once again attached by applying gentle pressure on clearomizer. The mouthpiece may be
cleaned with warm water. Make sure that it is completely dry before reinserting into the clearomizer.
Filling of E-Liquids
1. Unscrew the upper part below the mouthpiece counter-
clockwise from the tank.
2. Fill the clearomizer with e-liquid through the filling hole.
Please pay attention not to drip e-liquid into the airflow
tube in the middle of the device.
3. To close, screw the upper part back onto the tank, while
pushing down the component while turning it down. Please
make sure that no e-liquid can leak out.
Changing the Atomizer Head
1. Remove the clearomizer from the battery / box mod of your e-cigarette.
2. Screw the head base from the glass tank, while the mouthpiece points to the ground.
3. Remove the old atomizer head and insert a new one. Please first drip a few drops of e-liquid
directly into the wick of the coil to make it fully saturated before first use.
4. Connect all parts again and make sure that no e-liquid can leak.
5. Screw the clearomizer back to the battery / box mod.
KEY FEATURES & PERFORMANCE
Key Features of the SC GS Baby Clearomizer
Tank Volume
Diameter
Height (incl. Mouthpiece)
Material
Thread Type
Features
Top Filling
Airflow Control
Suitable Atomizer Heads
Steamax Heads from GS Air Series
Use the device only in combination with high-current batteries or box mods!
SC – WARRANTY & SERVICE
Warranty & Service
If the product ceases functioning or is defective in any way, please contact the specialist retailer
where you purchased the product. If you have any questions about the product's operation or its
use, please do not hesitate to contact our customer service department.
Please do not use accessories from other manufacturers in combination with this device. We
expressly point out that we cannot accept liability for damages that occur if the product is used
improperly, and that in such a case the product warranty will be void.
SC – CONTACT
SC Contact
InnoCigs GmbH & Co. KG
Stahltwiete 23
22761 Hamburg | GERMANY
Phone:
+49 (0) 40 – 22 86 729 0
Fax:
+49 (0) 40 – 22 86 729 99
E-Mail:
service@innocigs.com
GS Air Head
Top Cap
Glass Tank
Air channel component
2.0 ml
16.5 mm
57 mm
Stainless Steel and Glass
510
Mouthpiece
4
mm
Dimension of the e-liquid
tank's filling hole
Publicité
