Publicité
Les langues disponibles
Les langues disponibles
sYMbol Meaning
Alternating Current
Direct Current
Caution, risk of danger, refer to the operating manual before use.
Caution, risk of electric shock.
Earth (ground) Terminal
Conforms to European Union directives
The equipment is protected throughout by double insulation or reinforced
insulation.
Warning
• Adhere to local and national safety codes. Use protective equipment to prevent shock
and arc blast injury when working near hazardous live conductors.
• Use caution when working with voltages above 60V dc, 30V ac rms or 42V ac peak. Such
voltages pose a shock hazard.
• Always perform an autotest before and after using the tester.
• Max voltage for use: 690VAC between phases
• To avoid electric shock, do not touch any metal probe and naked conductor with hand or
skin.
• Never perform continuity test on a live circuit. However, in the event of an incorrect
operation, the tester provides protection up to 600V.
• Do not use the tester if it operates abnormally or if it is damaged.
• Do not operate the tester in a place where flammable or explosive gas (or dust) is
present.
• To avoid electric shock, do not hold the tester anywhere beyond the tactile barrier.
• Do not use the red test probe and the black test lead with other equipments.
• Remaining endangerment: When a probe or input terminal is connected to dangerous
voltage, this voltage can occur at the other probe or input terminal!
• When using the probes, keep your fingers behind the finger guards on the probes.
• Use only the test leads specified by the factory.
• Keep the tester out of reach of child and infant.
presenTaTion
The tester is a visual and audio tester for testing DC and AC voltage, continuity.
• phase/neutral identification
• a function for initial diagnosis of 30mA differential circuit breakers (RCDs)
• indication of phase rotation direction ( 2-wires method)
it has the following advantages:
• High level of electrical safety. The lighting and automatic AC/DC detection protect the
operator from a wide range of interpretation errors.
• The autotest allows you to confirm the operation of the internal circuits and the condition
of the leads.
• Mechanical robustness.
• Electronic protection up to 600V rms for continuity test when the circuit under test is live.
• High level of protection of the casing: IP 54
• Disconnectable red test probe and black test lead
• Centre distance of 19 mm (distance between the poles of the circuit breaker).
9
Publicité
