Publicité
FRONT PANEL CONTROLS
INPUT
1
A single jack socket is provided for connection to your instrument. This is a high
impedance input which allows for perfect matching to both passive and active guitars.
CHANNEL 1
VOLUME
2
This sets the level of channel 1 and also has an effect on the tone of this channel.
From low to medium settings the sound is bright and clean which will suit most clean
guitar styles. As it is increased the sound starts to break up slightly and responds well
to the player's dynamics; this creates classic cutting blues tones.
BOOST SWITCH
3
This provides a gain/volume boost that will depend on the setting of the VOLUME
control. With the switch set to BOOST, it is also possible to turn the boost on or off
using the master boost on the footswitch.
TONE CONTROLS
4
The tone controls are all passive and interactive.
TREBLE, MIDDLE and BASS all work in the conventional way and the operating
frequencies have been set specifically for vintage clean sounds. Being interactive
controls you will find that the TREBLE control has an effect on both the BASS and the
MIDDLE when a lot of treble lift is used. Passive controls were chosen
throughout the amplifier as they provide the best and the most natural kind of
equalisation for a guitar signal.
The PULL BRIGHT switch on the TREBLE control adds more high frequencies when
selected. It works in the traditional way, therefore as the VOLUME control is
increased the effect is lessened.
CHANNEL 2
GAIN
5
This control adjusts the degree of drive in channel 2. When used in conjunction with
the other controls on this channel, a wide range of clean and dirty sounds can be
achieved.
5
Publicité
