OK. OTD 202-D Mode D'emploi page 46

EN
OPERATION
Drying
• Press the Start button. The tumble dryer will
operate according to the pre-set program. The
Drying indicator lights up (fi g. 8, arrow 1).
• The remaining drying time is shown in the display.
• At the end of a drying cycle the laundry will run
through a 10 minute cooling cycle. The Cooling
indicator lights up (fi g. 8, arrow 2).
• The tumble dryer will stop operation
automatically when a drying cycle ends. The End
indicator will light up (fi g. 8, arrow 3).
• Open the tumble dryer door and take out the
laundry.
• If the laundry is not removed, the tumble dryer
will start the anti-crease protection automatically.
During the anti-crease protection cycle, the
tumble dryer's drum will run at intervals to keep your laundry loose.
Recommendation: Remove laundry immediately when the device has fi nished the
selected drying program.
Turning off the tumble dryer
• Set the program dial to 0 (fi g. 9). Disconnect the
power plug from the wall socket.
• Lightly push on the tumble dryer's door to open
it. Remove the dried laundry.
Tips for saving energy
• Spin the laundry as dry as possible in the washing machine before putting it into
the tumble dryer.
• Avoid overloading the tumble dryer.
• Shake the Iaundry and make it loose before loading it into the tumble dryer.
• Regularly clean the interior of the drum with a moist cloth.
• Choose a proper drying program. Make sure the laundry is not dried longer than
needed.
• Clean the fi lters after every drying cycle.
• Clean the condenser once a month.
OTD 202_A5_130723 (1.5).indb 46 OTD 202_A5_130723 (1.5).indb 46
46
8
9
22/7/13 4:13 PM 22/7/13 4:13 PM