Peraqua OCEAN VAC 2 FUN Mode D'emploi page 4

OCEAN VAC 2 FUN
AUTOMATIC POOL CLEANER
Operating instruction:
We congratulate you to buy this automatic pool cleaner!
Please check the delivery volume:
1. Safety instructions:
For the best cleaning results.
Manually clean pool before installing
cleaner.
For optimal suction....
Before you install the cleaner, make sure
you have cleaned the fi lter(including
backwashing) and emptied all baskets.
The ideal hose lengths is the distance
from the suction point to
the farthest corner + 2 lengths of hose.
To avoid damage to the pump..
Always make sure that your hose is full
of water before starting pump.
Do not allow swimmers in the pool while the
cleaner is in operation!
Warning! Suction is very dangerous!
2. Installation instruction:
Before operation :
+) Clean the fi lter (incl. backwashing) /
empty all baskets
+) The cleaner is fully assembled, place
it onto the rim of your pool.
+) Connect all sections of the vacuum
hose, put the grey end on your cleaner
head. (Fig. 1 - 3).
+) Mount the fl oat on your hose Fig. 4
ca. 70cm
+) Submerge the cleaner into the water
opposite the suction port
(skimmer).
+) Vertically submerge the hose into the
water so that the air can escape and the
hose will fi ll up with water.
+) Connect the hose with your suction
port (Fig. 5)
+) Turn on pump.
+) If necessarry close the other skim-
mers and the main drain (ideally the
right wheel should make approx. 8-12
turns per min. - Fig. 6)
A) 1 pc. OCEAN Vac 2 Fun
B) 1 pc. Float
C) 1 pc. Hose cone
D) 10 m. Hose
After cleaning :
+) Do not leave the cleaner lying in the
sun when not in use.
+) Take the hose sections apart and
store them straight! Fig. 7