Fiilex Q8 Travel Guide De Démarrage Rapide page 6

Turning The Light On
•
Insert the DC connector of the External Power Adapter into the Power Input Port (20)
until a click sound is heard. Plug the light into an appropriate outlet. The On/Off Button
(21) will light red to indicate it is in stand-by mode. Press the On/Off Button (21) to turn
on the Light. The On/Off Button (21) will light green to indicate it is in working mode.
• Positioning the Q8 Travel
To adjust the Q8 Travel, grasp the Handles (11) then loosen the Tilt Lock Lever (10).
Adjust the angle to the desired position the tighten the Tilt Lock Lever (10) to secure.
• Adjust Beam Angle
Adjust the beam angle by turning the Focusing Knob (6). The lens tube will extend,
moving back and forth from the lamp head housing.
• Mounting the Q8 Travel
The Q8 Travel can be mounted in a standing with the Junior Pin Receiver (7). In order
to mount the light, insert the stud of the C-Stand into the Junior Pin Receiver (7) and
secure by tightening the Stand Locking Pin (8).
• DMX Interface
The Q8 Travel is equipped with two DMX interfaces. RJ45 (18) or XLR Ports (17 & 22)
are used to send the DMX signal to the lamp head. Both interfaces include in/out ports
for the purpose of daisy-chaining the DMX line through to the next lamp head.
• USB Interface
The Q8 Travel is equipped with a Mini USB port (5V1A) for updating the Q8 Travel's
firmware. Please register your product at www.fiilex.com to be informed when firmware
updates are available.
3