Step 2: Installation - Strong SlimSat SA61 Manuel D'utilisation

Think about the way you might pass your cable in a discreet way from the SlimSat to your satellite
receiver. The antenna should not be too distant from your satellite receiver; a cable longer than 30 m
can decrease the quality of the signal.
Bad Quality Signal Reception

3.2 Step 2: Installation

In order to install your new antenna, you need to find the skew, elevation and azimuth angle by
referring to the table in the appendix of this user manual. If you can't find your location, please
refer to the information of the place nearest to your location. This user manual will show you the
installation example for the reception of ASTRA1 satellite in Brest region of France.
The angle information for Brest region is
Part assembly
1. Fixing the skew (joint of angle bracket and antenna body)
Join the angle bracket and antenna body with the supplied screw and adjust the skew angle to -19.7
2. Fixing the elevation (joint of antenna body and main support)
For the purpose of delicate adjustment of the elevation and azimuth angle, please don't fix the bolt
and nut tightly.
4
Skew:
El:
Az:
Check –
Good Quality Signal Reception
-19.7º
30º
149.6º
PART 1 • English