BTI MLL 360 Mode D'emploi page 8

- Level the MLL 360° using the levelling screws.
- To switch on the MLL 360°, press the "power button" (1).
The device will then be started automatically in the leveled horizontal operation.
To switch off the device, press the "power button" again.
- Within self levelling range the laser will perform fine adjustment automatically.
- Press the button "Horizontal" (2) or "Vertical" (3) to active or deactivate lines.
(1 x 360° horizontal / 4 x 90° vertical).
- Choose manual mode for deactivating automatic levelling.
- To activate the manual mode, press the "manual button" (4).
This mode is activated, when the orange control light is flashing.
You are now able to incline the laser lines as required. Therefor adjust the feet of the
laser device (screw up or down). For the precision adjustment press and hold the button
for "Horizontal" (2) or "Vertical" (3).
- Press the button „Detector"(5) to enter the detector mode. You can now use the laser
device with a laser detector. The detector mode is activated, when the control light is
flashing.
- With all laser lines activated, the MLL 360° emits the following beam pattern:
How to use the MLL 360°