KRESS AMT 132 Mode D'emploi page 9

AMT 132 - Buch Seite 9 Dienstag, 23. Mai 2000 9:14 09
AMT 132
3 Illustration
1 Saw blade
2 Saw stop plate
3 Pendulum stroke switch
4 Hand guard
5 Locking button for On/Off switch
6 On/Off switch
7 Battery
8 Battery locking
9 Battery charging unit
10 Clamping lever
Accessories illustrated or described are not always
included as standard delivery items.
4 Technical Data
Cordless Multi-Talent
Article number
Stroke rate at no load
Stroke length
Pendulum stroke steps
Pendulum stroke – can be
switched off
Weight with battery
Battery A132
Article number
(Spare parts no. 46416)
Type
Rated voltage
Capacity
Number of cells
Operating temperature range
Weight
Battery charging unit
Article number
(Spare parts no. 30858)
Input voltage
Output voltage
Charging current/time
Weight
5
Measured values determined according to
EN 50 260.
Sound pressure level:
Sound power level:
Work place emission value:
For operation, noise protection measures are
required.
The acceleration measured is usually less
than 2.5 m/s
6
The rated voltage of the battery must agree with the
value on the machine.
– The batteries are not charged. They therefore have
to be charged before use.
– A new battery develops full power only after it has
AMT 132
been subjected to approx. 5 charging and dis-
12 07 0103
charging cycles.
-1
0 – 2240 min
– The maximum service life of the batteries is
19 mm
attained if you charge these at an ambient temper-
1
ature of between +5 °C and max. +45 °C.
– If the battery is not within the permitted loading
•
temperature range (approx. +5 °C and +45 °C)
approx. 1.9 kg
charging time is extended by the cooling or warm-
up time.
– Important! Batteries will discharge even if the tool is
not used. They should therefore be re-charged reg-
98 02 4701
ularly.
NiCd
Or better still – connect the battery to the mains
13.2 V
charger which will automatically switch to mainte-
1.5 Ah
nance charging after the battery has been fully
11 charged. This is particularly useful for maintenance
and for the optimal operational readiness of the
+5 °C ... +45 °C
batteries.
0.8 kg
– Do not leave the battery in the charger if the latter
is not in operating condition.
MSL 60
To ensure long service life, the batteries should
98 03 3401 always be charged in good time. This is particularly
important if you notice a reduction in power ouput.
230 V ~
13.2 V
1. Remove battery 7 from the handle by simultane-
approx. 1.65 A/ ously pressing the locking device 8 .
approx. 60 min
2. Make sure that the mains voltage complies with
approx. 1.3 kg
the voltage on the name-plate on the charger.
Connect charger plug to mains.
3. Push battery into battery until it snaps into place.
Noise/vibration information
2
.
Charging the batteries
English
9
73 + 3 dB (A)
86 + 3 dB (A)
76 + 3 dB (A).