Installation - Alpina IVE-W585BT Guide De Référence Rapide

Installation

•
When making connections to the vehicle's electrical
system, be aware of the factory installed components
(e.g. on-board computer). Do not tap into these leads
to provide power for this unit. When connecting the
IVE-W585BT to the fuse box, make sure the fuse for the
intended circuit of the IVE-W585BT has the appropriate
amperage. Failure to do so may result in damage to the
unit and/or the vehicle. When in doubt, consult your
Alpine dealer.
1
Install at an angle between horizontal
and 30°. Note that installing at an angle
outside of this range will result in a loss of
performance and possibly damage.
0 - 30°
2
Mounting the Microphone.
For safe use, make sure of the following:
• location is stable and firm.
• driver's view and operations are not obstructed.
• microphone is located where the driver's voice
can be easily picked up (on the sun visor, etc.).
When you speak into the microphone, you should
not have to change your driving posture. This may
cause a distraction, taking your attention away
from safely driving your vehicle. Carefully consider
direction and distance while mounting the
microphone. Confirm that the driver's voice can be
easily picked up at the selected location.
Cable clamp
(Sold separately)
10
-EN
Microphone
Owner's manual
3
Remove the mounting sleeve from the
main unit.
This unit
Slide the unit into the mounting sleeve and
secure it.
Mounting Sleeve
(Included)
Dashboard
Rubber Cap
(Included)
Bracket
Pressure
1
Plates* Hex Bolt
(Included)
*1 If the installed mounting sleeve is loose in the
dashboard, the pressure plates may be bent slightly to
remedy the problem.
*2 The supplied face plate may be mounted.
Installation
Bracket keys
(Included)
This unit
2
Face Plate*
(Included)