Table des Matières
Publicité
IMPORTANT SAFEGUARDS
1. Remove the unit from the box and take off any protective wrapping.
2. Fix the 2 feet on bottom of convector heater by 4 screw
3. Place the heater on a smooth level surface and least 30cm away from any
obstacles.
4. Plug your heater into the power supply. Make sure your power supply
corresponds to the power indicated on the rating label.
5. Turn the thermostat switch clockwise or anti-clockwise to set the desired
temperature you require
Note: Do not force knob beyond its normal stop position.
FROST FUNCTION
If the appliance's thermostat knob is turned all the way counterclockwise to the
snowflake mark, the unit functions as a frost inhibitor, switching on below
cca.+5°C
OVERHEATING SAFE DEVICE
Your heater is fitted with a safe device that switches off the heater in the event
of overheating.
If the heater stops working, turn the heater off and inspect the blockage of inlet
or outlet. Disconnect the plug and wait at least 10 minutes for the protection
system to reset before attempting to restart the heater. If the safe device still
switches the heater off and makes the heater fail to operate, take the heater to
your nearest service center for examination or repair.
Attention: before restarting the heater, the plug must be disconnected for at
least 10 minutes.
11
OVERHEATING SAFE DEVICE
1. Always disconnect the appliance from the main supply before cleaning.
2. Clean the outside of the heater by wiping with a damp or dry cloth.
3. Do not use petroleum, any other detergent or chemical solvent to clean the
heater.
4. When the heater is not used for a long time, it should be protected from dust
and stored in a clean dry place.
Information requirment for the electric
local space heaters
Model identifier(s):CH-05/HK34523we
Item
Symbol
Value
Heat output
Nominal heat
Pnom
0.4
output
Minimum heat
Pmin
0.0
output (indicative)
Maximum continuous
Pmax,c
0.4
heat output
Auxiliary electricity
consumption
At nominal heat
elmax
0.427
output
At minimum heat
elmin
0
output
In standby mode
elSB
0
ENG
Unit
Item
Unit
Type of heat input, for electric storage
local space heaters only (select one)
manual heat charge control,
kW
No
with integrated thermostat
manual heat charge control with
kW
room and/or outdoor temperature
No
feedback
electronic heat charge control with
kW
room and/or outdoor temperature
No
feedback
No
fan assisted heat output
Type of heat output/room
kW
temperature control (select one)
single stage heat output and
kW
No
no room temperature control
Two or more manual stages,
kW
No
no room temperature control
with mechanic thermostat
Yes
room temperature control
with electronic room
No
temperature control
electronic room temperature
No
control plus day timer
electronic room temperature
No
control plus week timer
Other control options
(multiple selections possible)
12
Publicité
Table des Matières
