Technical Information; Installation Instructions; Before Using Your Appliance - Summit Appliance CT661BI Série Mode D'emploi

TECHNICAL INFORMATION

Model Numbers
Capacity
Electrical Input
Rated Current
Temperature of Freezer
Refrigerant
Installation
Ship Weight
Unit Dimensions (W x D x H)
*Units with suffix "ADA" or prefix "AL" are sized at 32" for use under in ADA compliant applications
NOTE: Specifications are subject to change without notice.

INSTALLATION INSTRUCTIONS

Before Using Your Appliance

• Remove the exterior and interior packing.
• Before connecting the unit to a power source, let it stand for approximately 2 hours. This will
reduce the possibility of a malfunction in the cooling system from handling during transportation.
• Remove the crisper, drip tray and shelves and clean them and the interior surfaces of the unit
with lukewarm water using a soft cloth.
Installing the Refrigerator-Freezer
•
Place the unit on a floor that is strong enough to support the appliance when it is fully
loaded. To level the unit, adjust the two leveling legs at the front.
• These models
can be installed either free-standing, recessed or built into an enclosure.
When installing as a free-standing unit, allow at least 2" (51mm) of space at the sides, top
and rear of the unit to allow for proper air circulation to cool the
compressor and condenser. Even when built in, the unit requires at
least 2" of clearance at the back, 1/8" (3mm) at both sides and 1/16"
(1.6mm) at the top. Take care that the air vents at the front of the
appliance are never covered or blocked in any way.
•
This appliance is supplied with spacers that have to be mounted
onto the condenser tube to make sure there is sufficient clearance
between the appliance and the wall.
CT661BI/CT661WBI (white)
CT663BBI/CT663BKBI (black exterior)
5.1 cu. ft.
115V AC/60Hz
1.3A
5°F
R134a: CT661BI, CT663BBI
R600a: CT661WBI, CT663BKBI
Built-in or free-standing
102 lbs.
23.63" x 23" x 33.25"
5