EASY FAST CIH000019NOC Manuel D'instruction page 9

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

HANDHELD SEWING MACHINE
HOW TO THREAD HANDY STITCH
Note :Thread should flow from the top right of bobbin or spool .Spring must be in
place before installing bobbin .
1 .Thread the Handy Stitch according to the diagrams 7,8,and 9.
2. Pass thread through the eyelet on needle arm (see diagram #7).
3. Pass thread over top of tension control .Do not wrap completely around tension
control
ADJUSTING THREAD TSNSION
1.lf stitching is too tight ,tum tension control slightly to the left.
2. If stitching is too loose,turn tension control slightly to the right.
3. Pass thread over top of tension control .Do not wrap completely around tension
control (see diagram #8)
4. Use threader to pass the thread through needle eye from back to front (see
diagram #9).
TO INSTALL A NORMAL THREAD SPOOL (SEE DIAGRAM #10)
1. loosen the bobbin nut and take off bobbin.
2. Slide thread spool into extension spindle.
3. Connect the extension spindle on bobbin shaft.
Right Way Wrong Way lb Replace Needle Loosen the set screw with a screwdriver
and take off old needle .
Always use a #14 style DHx 1 sewing needle .
Needle must be installed with flat side of needle shank facing the front of Handy
Stitch (see diagram #11).
To Replace Betteries (see diagram 11 ).
Note :Make sure machine is in the locked position prior to battery replacement.
9

Publicité

Table des Matières
loading

Table des Matières