IN&MOTION Airbag Vest Manuel Utilisateur page 35

1
Remove the recharge
1) Press downoard on the two side latches.
2) And remove the recharge in the same way indicated on the
drawing here enclosed levering with your thumb.
2
Unscrew the caps
3-6) Using the provided tool, unscrew the screw caps
RIGHT ORDER indicated on the
then n°2 and so on until cap n°4. Unscrew the caps until you see
the STOP and a red marking.
3
Push the pistons
7-10) Push the 4 internal pistons back with the tool until the
square windows are fully green.
Follow the indicated order: 1 - 2 - 3 - 4
4
Place the triggering ball
11) Place the triggering ball in the piston hole making sure that
it's well inserted.
Warning, make sure that the ball is well inserted in the silver
metallic piece.
5
Screw the caps back
12-15) Screw the 4 screw caps back, starting by n°4 up to the end
(until the two arrows are aligned) before going to n°3; 2 and 1.
Warning, always follow the indicated order!
6
Replace the recharge
16) Replace the new recharge by cliping it over the bottom part
and put back the elastic to maintain the recharge.
Check our tutorial video on our Youtube In&motion
channel, or contact us at:
horsesupport@inemotion.com
drawing, starting by the cap n°1,
EN
IN THE
33