Application; Using The Connect Wi-Fi Receiver; Wi-Fi Connection; Resetting Parameters - Fnac ELIPSON Manuel D'utilisation

EN
IV. USING THE CONNECT WI-FI RECEIVER
After connecting the streamer to your amplifier, plug in the power supply.
The Connect Wi-Fi Receiver can be connected directly to the back of your Hi-Fi
system. However, the standardized distance between the two RCA connectors
on the streamer and the one on your amplifier or any other component may
be different. Do not force when connecting it, if the connectors do not match,
use the supplied RCA cable extension.

WI-FI CONNECTION :

In order to successfully connect your Elipson Connect Wi-Fi Receiver to
your home network follow the detailed instructions in our Elipson Connect

application.

Do not hesitate to refer to the tutorials on our website if you encounter any
difficulties during the process.

RESETTING PARAMETERS :

Hold down the "RESET" button on the back of the streamer until you hear the
message "Restore to factory settings" and observe the simultaneous flashing
of the LED on the device.
18
V. IN CASE OF BREAKDOWN
DO NOT USE ANY KIND OF CLEANING SOLUTION OR CLEANSER ON THESE UNITS.
IF FOR SOME REASON THE AMPLIFIER NEEDS TO BE REPAIRED, PLEASE CONTACT
US IMMEDIATELY. WE WILL ISSUE A RETURN AUTHORIZATION NUMBER. THIS UNIT
SHOULD NOT BE SHIPPED BACK TO ELIPSON WITHOUT THE RA#.
DO NOT ATTEMPT TO OPEN OR DISMANTLE THIS DEVICE.
THIS WILL VOID THE WARRANTY !
POSSIBLE BREAKDOWN :
The product connects and disconnects from the Wi-Fi network.
• Check that the broadband of your Wi-Fi network is sufficient.
• Check that the device is not too far from the router
You cannot connect to the Wi-Fi network:
• Make sure you are using the 2.4 GHz band on your router and not the 5
GHz band.
You cannot connect the unit to your amplifier:
• If the spacing between the two RCA sockets does not match the spacing
of your amplifier, use the cable supplied with the product.
No sound on a channel:
• Check the connection to the amplifier
19