Peach PBP350 Mode D'emploi page 7

6. The finished laminated pouch is ejected from the foil
ejection opening (back side) F . Make sure that there
is enough space behind the device to allow the pouch to
exit unhindered. Let the laminated pouch cool down for at
least one minute before touching it.
COLD laminating:
The green READY indicator D lights up as soon as the
selector switch B is in the (COLD) position. The machine
is ready for cold laminating.
Note: For cold laminating special laminating pouches
must be used. These are not included in the starter
package.
Note: To switch from HOT to COLD laminating, move the
selector switch B to the (COLD) position. It takes several
minutes to cool down the machine. Wait at least 10
minutes before starting cold laminating. Otherwise, the
laminated document may be damaged, which may cause
damage to the machine itself.
Jammed laminating pouches
If the pouch has been pulled in at an angle or is jammed
in the device, please proceed as follows.
1. Switch off the device by setting the power switch A
to position "0". The indicator C (POWER) goes out. The
laminating pouch will not be drawn in any further.
2. Push the anti-blocking switch G aside and hold it in
this position.
3. Pull the laminating pouch out of the machine by hand.
4. Start the laminating process again.
Cutting
Caution: The cutter blades are very sharp! Never touch
or grasp the cutting blades!
1. Move the cutter head H to one side of the guide rail
K .
2. To choose the desired cutting style (straight, wave
or perforation) pull the setting lock I upwards to the
"Open" position.
3. Turn the blade selector J until the symbol related to
the required cut (straight, wave, perforation) is at the top.
4. Press the setting lock I downwards to the "Lock"
position.
5. Put the material to be cut under the transparent press
rail L at the required position. Align a straight edge of
the material with the visual positioning grid M.
Note: A maximum of 3 sheets (80g/m
once.
6. Hold the material to be cut firmly with one hand so
that it can't slip during cutting. Otherwise the cut may be
inaccurate.
7. To complete the process, press the cutting head H
down and slide it along the guide rail K to the other side.
Note: To prevent a faulty cutting edge, do not run the
cutting head back again but remove the cut material
directly after completing the cut.
Replacing the Cutting Head
If the blades of the trimmer have become dull, they can
be replaced. New cutting heads, fully assembled with
three blades, are available from your Peach dealer or at
www.peachstore.com
1. Remove the end cap O by sliding it up.
2. Insert the new cutter head, reinstall the guide rail and
push the end cap O back into its original position.
Caution: Do not touch the blades - they are extremely
sharp!
Operation of the corner rounder
The corner rounder O is located in the bottom of the
unit, so that it is always ready to hand. It produces a
clean, rounded corner simultaneously on up to 3 sheets
2
(80g/m
1. Remove the corner rounder from the machine and
place it on a stable work surface.
2. Position the document in the silver corner.
3. Press the raised button down firmly.
2
) can be cut at
) or on a laminated document.