Publicité
Les langues disponibles
Les langues disponibles
1074, Avenue des Carrières – Z.A la Plaine du Caire III
13830 ROQUEFORT LA BEDOULE – FRANCE
www.ermax.fr - E-Mail : accueil@ermax.fr
Fitting kit
- 3 fitting brackets
- 4 screws BHc 5×15 small head
- 4 rubber inserts M5
- 1 piece of protective adhesive film
- 2 small self-adhesive rubber stops
Fitting instructions
- Place the rubber inserts M5 in the holes inside the Ermax seat cowl.
- Place the fitting brackets on the seat cover and glue the rubber stops to the places shown on the photo below.
- The provided self-adhesive film can be cut and glued between the rear fairing and the edge of the seat cowl (to
protect against the scratches).
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of our
painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* The mentioned label of motorbikes's manufacturers are indicated exclusively as a reference to Ermax accessories.
* Care to excessive clampings which may damage or break our plastic accessories and aluminium screws.
Self-adhesive rubber
stops location
« CAUTION »
FITTING INSTRUCTIONS
ADAPTABLE ON YAMAHA MT 07 2018 →∞
Estimated mounting time : 30 mn
Once the seat cowl is fitted,
check that it's correctly clipped
while trying to lift the front.
EN
Date : 29/05/18
ERMAX SEAT COVER
Publicité
