Publicité
STEP 1
Remove the side panel by
using the included allen
wrench and unscrewing the 2
M4 x 4MM Hex head screws
STEP 2
Place additional battery (P1) into available slot. Plug the yellow quick
connect plug attached to the black and red braided cables on the
battery to an available quick connect on the circuit board as shown.
The battery will have additional sets of red and white wires that are not
used in this installation. The sets of red and white wires are only used
when replacing the main battery.
Re-install the side panel.
Note: Ensure cords are routed towards the center of the column to
avoid interference with re-installation of the door.
UPDATED AS OF: 06/19/2018
If adding a 3rd battery.
P1
4 of 4
Publicité
