Operating And Safety Instructions - Unitec 77 082 Mode D'emploi

77082 Bed._110714:Lay
GB

Operating and safety instructions

This UNITEC LED daytime running lamp has been very carefully designed and
manufactured so that it always works reliably. Before using the LED daytime
running lamp, please read through the instructions carefully. Here you will find
everything that you need to know and observe so that your LED daytime running
lamp will give you many years of good service. Please retain these instructions
in case you need to consult them later.
Please observe the permitted fitting width and
height (see Fig. 1). The distance between the two
LED daytime running lamps must be at least
600 mm. The maximum distance of 400 mm from
the end of each LED daytime running lamp to the
outside edge of the mudguards must be observed.
The minimum distance of each LED daytime
running lamp to the carriageway must be at least
250 mm. The max. fitting height is 1,500 mm to the
carriageway. The two LED daytime running lamps must be fitted at the same
distances from the outside edge of the vehicle and the ground.
Please disconnect the battery terminals whilst working on the electrics since
a short circuit or even injury might otherwise occur. If during fitting you have
any uncertainties or concerns about your personal abilities, please contact a
specialist garage.
Suitable for 12 V DC operation.
LED output about 4.2 Watt
Once the LED daytime running lamp has
been fitted in the appropriate position on
your vehicle in accordance with the
instructions in Figure 1, it now has to be
connected to the onboard electronics.
To this end please observe the circuit
diagram provided (Figure 2).
1. Attach the yellow lead to the
+ (positive) cable of a sidelight.
2. Connect the black cable to the – (negative) terminal of the battery or to
a suitable earthing point on the bodywork.
3. The red cable is connected directly to the + (positive) terminal of the battery.
4. Choose a suitable attachment point for the electronics box (starter) and attach
it with suitable screws or brackets. The cable and electronics box (starter)
must be attached out of the range of rotating or moving parts in the engine
compartment and must not be subject to excessive heat from the engine or
the cooling system.
5. Connect both connectors of the daytime running lamp to the sockets of the
electronics box (starter).
Please note that the LED daytime running lamp only works properly when the
engine is running. When first installed, the LED daytime running lamp comes on
for about 30 seconds as a test and it goes out as soon as the motor vehicle's
engine stops.
It may occur that the installation of the LED daytime running lamp leads to
faults or error messages on the onboard monitoring system (onboard computer).
If this occurs, please contact a specialist garage. The garage can then if
necessary remove or correct the fault.
Once successfully installed, the LED daytime running lamp should operate when
the engine is switched on. After that we would ask you to continue to check
whether or not the LED daytime running lamp switches off when the original
dipped headlights are switched on.
At the end of its useful life, do not dispose of this product in the domestic waste
but take this product for professional disposal. Your public waste disposal
authority will be happy to give you any further assistance.
For cleaning use only water, mild soap and a soft cloth. Do not use solvents
such as spirit or petrol. Solvents may corrode the material.
14.07.2011 14:19 Uhr
Fig. 1
Fig. 2
Yellow cable
click
Black cable
Seite 3
Welcome
Safety instructions
Technical data:
User instructions
Starter
click
Red cable
Disposal instructions
Cleaning