Safety Instructions; Technical Data - Metal Works CAT25ALU Mode D'emploi

Safety instructions

• Read, study and understand all warnings and operating instructions prior to use.
• Do not overload this jack beyond the rated capacity.
• This jack is designed for use only on hard level surfaces capable of sustaining the load.
• This is a lifting design only. The load must be supported immediately by other appropriate means.
• Do not move or dolly the vehicle while on the jack.
• Lift only on areas of the vehicle as specified by the vehicle manufacturer.
• Center the load on the saddle prior to lifting.
• Some vehicles require an adapter to properly engage the frame for lifting. Use vehicle manufacturer's instructions on
proper lifting.
• No alterations to the jack should be made.
• Failure to heed these warnings may result in personal injury and/or property damage.
Because of the potential hazards associated with the misuse of equipment of this type, no
alterations should be made to the product without authorization of the manufacturer of supplier.

Technical data

Model
Capacity
Minimum height
Maximum height
Lifting height
Dimensions
Weight
Spare parts : see page 10
Assembling your jack
Please check that you have all of the parts listed below:
• Aluminium jack chassis.
• Pumping handle in two parts.
First, remove the retaining clip: Press the yoke down and then pull the retaining clip out from the hole in the base (as
picture).
Operation
The owner and/or operator is responsible for providing maintenance, maintaining all labels and while in use,
maintaining the unit in work order.
Make sure the operator understand these operating instructions.
The owner/operator should keep these instructions for future reference.
6
®
CAT25ALU
T 2,5
mm 100
mm 460
mm 360
mm 650 x 292 x 170
kg 26
CAT25ALU - NLFRENES - v1.1 - 03012014
Press down
Safety clip
Pull
EN