Isotronic H1 Mode D'emploi page 12

There are three operating modes:
Operation via USB (without rechargeable batteries)
A) LED is permanently lit green in all switch positions (OFF, woof1,
woof2)
B) When barking is triggered, the results display flashes red 3 times
every 5 seconds
C) Reset results display switch to OFF position
Operation via USB (with rechargeable batteries)
A) LED is lit green in all positions (flashes when charging,
permanently lit when charged)
B) When barking is triggered, a result is displayed (flashes red 3
times every 5 seconds)
C) Reset results display switch to OFF position
Operating only on rechargeable batteries
A) LED is briefly lit green only once when you turn on woof1 or woof2
B) When barking is triggered, a result is displayed (flashes red 3
times every 5 seconds)
C) Reset results display switch to OFF position
At low battery display, LED lights up green 3 times every 5 seconds
Technical data
Battery-operated:
Displays:
USB-operation:
USB charging:
Switch:
Operating temperature and huminity: - 20C° to +50 C° and ≤ 90% R.H.
Storage temperature and huminity:
Replacement of the rechargeable battery
1. Unscrew and remove the housing cover.
2. Remove the old rechargeable battery from its fitting.
3 x 1,2 V DC AAA Micro NiMH 850 mAh
rechargeable batteries (included)
LED indication for charging
(blinking when charging, permanent light when
fully charged)
cable included
approx. 12 hours, overcharging protection integrated
Max. charging current 5V DC <500mA
OFF
ON woof1 (small aggressive dog)
ON woof2 (large aggressive dog)
- 5C° to +50 C° and ≤ 90% R.H.