Attas MIDO 433 Mode D'emploi page 8

ENGLISH
2. PROGRAMMING THE HAND TRANSMITTER
2.1 How to program the hand transmitter?
1. Press shortly the button „P" on the headstock cover. The red LED light on the
headstock cover starts blinking and signalize the programming oft the hand
transmitter.
2. Press the desired hand transmitter button as long as the red LED light starts
blinking fast.
3. Release the hand transmitter button und and press it again within 15 seconds
as long as the red LED light starts blinking really fast.
4. Release the button. The red LED light shines constant and the hand
transmitter is programmed.
2.2 How to program the hand transmitter with an external receiver?
1. Press the button „P" on the receiver for. 1 second. The number of the first
vacant memory location appears flashing in the 7-segment displays. If the first
memory location were not yet occupied, it would appear as „00".
2. By using the „+" or „-" buttons, you can now page through from one memory
location to the next.
3. Press the hand transmitter button for 1 second.
-> the right-hand decimal point extinguishes and the left-hand lights up
4. Press the same hand transmitter button once again. Now both decimal points
light up and the number shines constant. The hand transmitter button has
been successfully registered.
5. To quit the memory location menu and return to the normal operation mode
press the button „P" for 1 second.
7