PCM P03-GSP-118 Mode D'emploi page 2

English
1. To fix the tool holder on the machine,
introduce the shank then adjust the
slope wished by means of the adjusting
screw (1) and the reference surface (2).
Tighten the 2 fixing screws (3)
(important, make sure that the screws
have the same clamping force).
3
1
2. Adjust the offsets of the position.
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating instructions
Betriebsanleitung
Istruzioni per l'uso
P03-GSP-118
2
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Garant:
BT
Validation : 15.09.2015
3. When mounting or dismounting of
cutting tools, spindle lock on the planes
provided for this purpose, using an
adapted wrench.
REMARK: The use of this tool holder
requires the change of position of the
horn (see plan below) to allow the
access for the back spindle to take the
part.
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email:
Document :
P03-GSP-118 1-
Mode d'emploi 1-
Page : 2 de 4
office@pcm.ch