Publicité
Les langues disponibles
Les langues disponibles
Putting into operation
Before putting into operation, please fully charge the batteries (at least 12 hours, even
if the charging indicator light is on steady). Only use the device after that.
The charging indicator light flashes green during the charging process. Once the
batteries are fully charged, the indicator light is on steady. When the charging process is
ended or the USB cable is disconnected from the device, the indicator light turns off and
the device is ready for mobile use.
Technical data
Battery-operated:
PIR-effective range:
Frequency:
Displays:
USB-operation:
USB charging:
Switch:
Operating temperature and huminity: - 20C° to +50 C° and ≤ 90% R.H.
Storage temperature and huminity:
Replacement of the rechargeable battery
1. Unscrew and remove the housing cover.
2. Remove the old rechargeable battery from its fitting.
3. Insert a new rechargeable battery size Micro (AAA) and type Ni-MH with 1.2 V and
850 mA. When doing so, mind the correct polarity as shown on the bottom inside the
battery fitting.
4. Reattach the casing cover to the casing body and screw the casing in place again.
General information
1.
Electric appliances, packaging material etc. should be kept away from children.
2.
Dispose packaging and worn out material correctly and in an environmentally
friendly way.
3.
Do only pass on the device including the operation manual.
4.
Subject to change of design and technical data without notice for the sake of
constant product improvement.
Instruction for safe use:
Important: Damage caused by not adhering to the operating instructions is not covered
by guarantee. ISOTRONIC accepts no liability whatsoever for any resulting consequent
damages.
- Only operate the device at its intended voltage.
- In case of repairs, only use original spare parts, to avoid serious damage.
- If the supply cord is damaged, it must be replace by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.
- Repairs or other works, e.g. changing a fuse, etc. may only be carried out by an
appropriately trained, skilled person.
3 x AAA Micro 850 mAh rechargeable batteries (included)
approx. 6 - 8 m/120°
18 - 24 kHz +/- 10%, max. 110 dB
LED indication for charging
permanent light when fully charged)
cable included
approx. 12 hours, overcharging protection integrated
OFF- ON = PIR + sound or ON sound
- 5C° to +50 C° and ≤ 90% R.H.
(blinking when charging,
Publicité
