Star TCP400 Série Manuel D'utilisation page 85

To change the DIP switch settings, do the following.
1. Check that the power is turned off for both the reader/writer and the host computer.
2. Remove the two screws.
3. Pull out the interface card to remove it.
4. Change the DIP switch settings on the interface card.
5. Push in the interface card to mount it.
6. Tighten the two screws.
7. Turn on the power for both the reader/writer and the host computer.
Note: The new settings will take effect when the reader/writer power is turned back on.
A-2. USB Interface Specifications
1 Communication Rating
2 Communication Speed
3 Communication Method
4 Power Specifications
5 Connectors
DIP-Switch
Conforms to USB 2.0 Specifications
USB Full Speed Mode (Max. 12 MBPS)
USB Bulk Transmission Mode
USB Self-power Function
Type-B
– 82 –