Cleaning And Maintenance; Noise Emission; Technical Specifications - BOMANN HSM 8006 CB Mode D'emploi

Outlining and Shaving the Neck
• The clipper head allows outlining the shape of the beard, even in difficult to reach places
as well as shaving the hairline at the neck.
• Turn the hair clipper off with the switch (2).
• Remove the comb attachment and turn the device on again.
Finish Operation
Slide the On/Off switch (2) after use to the position "0" and disconnect from the mains.
Regular cleaning and maintenance ensures optimum results and long lifetime.
WARNING:
• Turn the device off and disconnect the mains plug.
• Do not submerge the unit in water. This would cause electric shock or fire.
CAUTION:
• Do not use a wire brush or other abrasives.
• Do not use sharp or abrasive cleaning agents.
• Use the cleaning brush to remove remaining hair after use.
• Therefore, take off the comb attachment.
• Regularly apply 1 - 2 drops acid-free oil to the clipper head.
• Clean the casing with a slightly damp cloth, if necessary.
The workplace-related emission value is less than 70 dB(A).
Model: ..................................................................................................................HSM 8006 CB
Power supply: ..............................................................................................230 -240 V~, 50 Hz
Power consumption: ..................................................................................................max. 10 W
Protection class: ....................................................................................................................... II
Net weight: ...................................................................................................... approx. 0.405 kg

Cleaning and Maintenance

Noise emission

Technical Specifications

GB
35