ALPS Lite Manuel D'utilisation page 12

Important! Open the filter location cover, and remove the filter, and
remove its plastic packaging before use. Then install the composite filter
in the purifier.
● Place the purifier at least 1 meter from equipment that emits electromagnetic
waves (television, radio, clock, etc.) to reduce the risk of interference.
● Do not cover the air inlets and outlets of the purifier (e.g. do not place it in
contact with a curtain).
● Do not use in a place exposed to strong temperature contrasts and therefore
to condensation.
● Do not use the purifier in extreme temperatures: stay between 1°C and 35°C.
● The purifier should be installed in a stable position and in a well-ventilated
location. If it is placed on a thick carpet, it may swing slightly.
● Do not use in thick smoke. You must first ventilate the room before purifying
the air.
● Keep enough space around the purifier. Air purification works best if the
purifier is placed in a place where air can circulate easily.
Interface Control
Control panel
Instructions
When the ALPS Lite purifier is connected and switched off, the
On / Off indicator light is lit red.
Start / Stop: touch button to switch the purifier on or off. The
ionizer activates automatically when the purifier is on.
Fan speed: touch button to change the fan speed (successive
presses to go from 1> 2> 3> 1).
12 | P a g e
1: Night mode
2: Speed 1/2/3
3: On / Off
4: Filter change indicator
5: Parental lock