Getting Started; Battery Installation - One Touch KC25 Mode D'emploi

Getting Started

CHANGING BLADE
1. Remove all Plungers.
2. Press the Power Head Release Button and
remove the Power Head.
3. Remove the End Cap near the blade holder
and take out the Cutter Plate (Fig.1).
4. Remove the blade from the Cutter Plate by a
coin or similar item (Fig.2) and replace with
your desired blade. (Fig.3).
5. Insert the Cutter Plate back into the Chassis
and close it by replacing the End Cap.
(If battery installation is needed, please proceed to the next
section "Battery Installation".
6. To lock the Power Head back onto the chassis,
introduce the round end first and engage the
Locking Tab first (Fig.5).
7. Press the Power Head down and make sure
that the Power Head is attached properly.
NOTE: To prevent accidental cuts from spare blade, always put
the blades not in use, sharp edge down, into the Blade Holder.

BATTERY INSTALLATION

1. Remove all Plungers.
2. Press the Power Head Release Button and
remove the Power Head
3. Slide open the battery door, remove and
install 4 AA alkaline or rechargeable batteries
into the battery compartment according to
polarity (+/-) instruction (Fig.4).
4. Replace the battery door.
5. To lock the Power Head back onto the chassis,
introduce the round end first and engage the
Locking Tab first (Fig.5) .
6. Press the Power Head down and make sure
that the Power Head is attached properly.
PLUNGER ASSEMBLY
1. Insert the Stock Plunger into the Small Plunger
to become a Plunger Assembly (Fig.6).
2. Insert the Plunger Assembly into the Larger
Plunger to become a Larger Plunger Assembly.
NOTE: Always engage the Stock Plunger into the Small
Plunger during operation. Do not use them separately.
.
10
Fig.1
Fig.2
1
2
Fig.3
1
Fig.4
Fig.5
Fig.6
2