Electrical Connection - Hotpoint MHR 940.1 /HA Mode D'emploi

Electrical Connection

Those ovens equipped with a three-pole power
supply cable are designed to operate with an
alternating current with the voltage and frequency
indicated on the data plate (located on the
appliance) and in the instruction manual. The wire for
earthing the appliance is yellow-green in colour.
Replacing the cable
Use a rubber cable of the type H05VV-F with a
suitable cross section 3 x 1.5 mm².
The yellow-green earth wire must be 2-3 cm
longer than the other wires.
Opening the terminal board:
• Using a screwdriver, prise on the side tabs of the
terminal board cover;
• Pull open the cover of the terminal board.
To install the cable, proceed as follows:
• Remove the wire clamp screw and the three
contact screws L-N-
• Fasten the wires beneath the screwheads using
the following colour scheme: Blue (N) Brown (L)
Yellow-Green
• Fasten the supply cable in place with the clamp
and close the cover of the terminal board.
Connecting the supply cable to the mains
Install a standardised plug corresponding to the load
indicated on the data plate. When connecting the
cable directly to the mains, install an omnipolar
circuit-breaker with a minimum contact opening of 3
mm between the appliance and the mains. The
omnipolar circuit breaker should be sized according
to the load and should comply with current
regulations (the earth wire should not be interrupted
by the circuit breaker).
The supply cable should be positioned so that it
does not reach a temperature of more than 50°C with
respect to the room temperature, anywhere along its
length.
Before making the connection, check that:
• The electrical safety of this appliance can only be
guaranteed if the cooker is correctly and
efficiently earthed, in compliance with regulations
on electrical safety. Always ensure that the
earthing is efficient; if you have any doubts call in
a qualified technician to check the system. The
manufacturer declines all responsibility for
damage resulting from a system which has not
been earthed.
• Before plugging the appliance into the mains,
check that the specifications indicated on the
date plate (on the appliance and/or packaging)
correspond to those of the electrical mains
system of your home.
• Check that the electrical capacity of the system
and sockets will support the maximum power of
the appliance, as indicated on the data plate. If
you have any doubts, call in a qualified
technician.
• If the socket and appliance plug are not
compatible, have the socket replaced with a
suitable model by a qualified technician. The
latter, in particular, will also have to ensure that
the cross section of the socket cables are
suitable for the power absorbed by the appliance.
The use of adapters, multiple sockets and/or
extensions, is not recommended. If their use
cannot be avoided, remember to use only single
or multiple adapters and extensions which comply
with current safety regulations. In these cases,
never exceed the maximum current capacity
indicated on the single adapter or extension and
the maximum power indicated on the multiple
adapter.
N L
! Once the appliance has been installed, the power
supply cable and the electrical socket must be
easily accessible.
! The cable must not be bent or compressed.
! The cable must be checked regularly and replaced
by authorised technicians only (see Assistance).
! The manufacturer declines any liability should The manufacturer declines any liability should The manufacturer declines any liability should The manufacturer declines any liability should The manufacturer declines any liability should
these safety measures not be observed. these safety measures not be observed. these safety measures not be observed. these safety measures not be observed. these safety measures not be observed.
GB
15