nedis FLLMB10W Manuel De L'utilisateur page 5

Technical data
KNLEDFLMB10W
KNLEDFLMBUK10W
Input voltage 12/24V DC
Wattage 10 W
Ingress protection class
IP65
(IP code)
Luminous flux 700 lm
Colour rendering index (CRI) 75
6500K +/- 400K
Colour temperature
(Daylight white)
Beam angle 120°
Charging duration 5 hours
4 hours
Operating hours
4400 mAh / 7.4 V
Ambient temperature -20 °C ~ 40 °C
Dimensions (LxWxH) 164x148x216 mm
Weight 1230 g
Warranty
Floodlight 2 years
Battery 1 year
Safety
General safety
• Read the manual carefully before use. Keep the
manual for future reference.
• Only use the device for its intended purposes.
Do not use the device for other purposes than
described in the manual.
• Do not use the device if any part is damaged or
defective. If the device is damaged or defective,
replace the device immediately.
• The device shall not be used by children without
the supervision of an adult. Children shall not
play with the device.
• Do not modify the device in any way.
• Do not expose the device to water or moisture.
• Keep the device away from heat sources.
• Do not block the ventilation openings.
• Do not look directly into the LED lamp.
• Observe the minimum distance between the
lamp and the surface being illuminated. The
minimum distance is 2 metres.
Electrical safety
KNLEDFLMB20W
KNLEDFLMBUK20W
12/24V DC
• To reduce risk of electric shock, this product
20 W
should only be opened by an authorized
IP65
technician when service is required.
1400 lm
• Disconnect the product from the mains and
75
other equipment if a problem should occur.
6500K +/- 400K
(Daylight white)
Warranty
120°
5 hours Any changes and/or modifications to the product
4 hours
will void the warranty. We cannot accept any
8800 mAh / 7.4 V
liability for damage caused by incorrect use of the
-20 °C ~ 40 °C
product.
216x184x319 mm
2446 g
2 years
1 year
Disposal
• The product is designated for separate
collection at an appropriate collection point.
Do not dispose of the product with household
waste.
• For more information, contact the retailer or the
local authority responsible for waste
management.
Documentation
The product has been manufactured and supplied
in compliance with all relevant regulations and
directives, valid for all member states of the
European Union. The product complies with all
applicable specifications and regulations in the
country of sales.
Formal documentation is available upon request.
The formal documentation includes, but is not
limited to the Declaration of Conformity, the
Material Safety Data Sheet and the product test
report.
Disclaimer
Designs and specifications are subject to change
without notice. All logos, brands and product
names are trademarks or registered trademarks of
their respective holders and are hereby recognized
as such.
5 5
English