HTC HTT-31 Manuel De L'utilisateur page 5

5
Using both holes predrilled at the top of
each leg, attach the Long Top Support J.
Repeat on other side.
6
Using both holes predrilled at the top of each
leg, attach the Short Top Support K.
Repeat on other side.
7
Using the (8) supplied Phillips Wood Screws
D and the (8) washers attach the table top.
• Line up predrilled holes in the bottom of
the table tops M and N with the slots
in the Short Top Supports K.
• Be sure the measurements printed on
the table top match up before attaching.
• Make sure the table top is flush with the
longer sides before tightening*
*
If attaching a machine larger than the
table top in closed position, adjust the slats
appropriately before tightening.
8
Insert the Center Shelf Boards as shown.
5