Product Specifications - T'nB HPBLED1 Mode D'emploi

AUDIO INPUT (AUX-IN MODE)
In addition to Bluetooth, this speaker
can play music using the 3.5mm audio
cable included in the box.
1. Using the 3.5mm audio cable,
connect the speaker to a smart device
with 3.5mm audio port.
2. Press and hold the button to enter
AUX mode. The speaker will emit one
short beep when connected.
3. When in AUX-IN mode, some
speaker functions may have to be
operated from the smart device.
If there is no sound during AUX-IN
mode, check to ensure the speaker is
not already paired via Bluetooth.
CHARGING THIS DEVICE
1. The speaker will emit 3 descending
beeps when battery is low
2. Using the 2-in-1 cable included in
the box, connect the speaker to a USB
charging port.
3. The charging indicator will turn
red when charging and then tum off
when the speaker is fully charged.
Approximate charging time is 2-3 hours.
HPBLED1_NOTICE.indd 3
It is recommended to disconnect
the charging cable after charging is
complete. Do not leave the charging
cable inserted when the speaker is
not in use.

PRODUCT SPECIFICATIONS

• Bluetooth connection range:
10 meters
• Charging time: Approximately
2-3 hours
• Battery: built-in 1000mAH Li-battery
• Charging input: 3.7V 1A
• Speaker output power: 3W
SAFETY
• This speaker is not water-resistant.
Keep away from wet or damp
surroundings
EN
16/12/2016 11:46