SOLAC KT5857 Mode D'emploi page 9

INSTRUCTIONS FOR USE
BEFORE USE:
Make sure that all the product's packaging has
•
been removed.
Before using the product for the first time it is
•
advisable to boil water within, so as to remove
all remaining dust and impurities.
Before using the product for the first time,
•
clean the parts that will come into contact with
food in the manner described in the cleaning
section.
FILLING WITH WATER:
Remove the kettle from its base before filling it.
•
Fill by lifting the lid, clicking on the button (I)
•
Fill the receptacle taking care to observe the
•
MAX and MIN leve.
Put the kettle on its base
•
Ensure that the lid is closed
•
USE:
Take the length of cable required out of the
•
housing.
Attach the appliance to its base making sure
•
that it is correctly fitted into place.
Connect the appliance to the mains.
•
Turn the appliance on, by using the on/off
•
switch.
The pilot light comes on.
•
Once the water has boiled the appliance will
•
switch off automatically.
The appliance can be switched on again using
•
the switch once the control device has cooled,
if it is not switched on again, do not force it,
allow it to cool.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
Unplug the appliance from the mains.
•
Remove the water from the inside of the ap-
•
pliance.
Put the cable back in the cable housing.
•
Clean the appliance.
•
NOTE: To assemble / disassemble the filter,
•
follow the illustration at the beginning of the
manual (Fig.1).
CABLE COMPARTMENT
This appliance has a cable compartment situ-
•
ated on its underside.
CARRY HANDLE/S:
This appliance has a handle on the side of the
•
body, which facilitates comfortable transport.
CLEANING
Disconnect the appliance from the mains and
•
allow it to cool before undertaking any cleaning
task.
Clean the electrical equipment and the mains
•
connection with a damp cloth and dry. DO NOT
IMMERSE IN WATER OR ANY OTHER LIQ-
UID.
Clean the equipment with a damp cloth with a
•
few drops of washing-up liquid and then dry.
Do not use solvents, or products with an acid
•
or base pH such as bleach, or abrasive prod-
ucts, for cleaning the appliance.
Neither parts of this appliance are suitable for
•
cleaning in the dishwasher.
HOW TO DEAL WITH LIME SCALE INCRUS-
TATIONS:
For the appliance to work correctly it should be
•
kept free of limescale or magnesium incrusta-
tions caused by the use of hard water.
To prevent this kind of problem, we recom-
•
mend the use of water with low lime or magne-
sium mineralisation.
However, if it is not possible to use the kind of
•
water recommended above, you should peri-
odically remove the limescale from the appli-
ance:
Every 6 weeks if the water is "very hard".
•
Every 12 weeks if the water is "hard".
•
A specific anti-lime scale product should be
•
used on this kind of product.
Homemade solutions are not recommended in
•
the decaling of this appliance, such as the use
of vinegar.
ANOMALIES AND REPAIR
Take the appliance to an authorised technical
•
support service if product is damaged or other
problems arise. Do not attempt to disassemble
or repair the appliance yourself as this may be
dangerous.
In case of breakdown call the customer service
•
telephone number indicated in the guarantee
sheet. Do not attempt to disassemble or repair
the appliance yourself as this may be danger-
ous.
EN