Publicité
Les langues disponibles
Les langues disponibles
English
1. To fix the tool holder to the machine,
introduce the shank.
Then tighten the 3 screws of fixations
(Important, make sure that the screws
have the same strength of tightening).
2. Adjust the offset of the position.
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating instructions
Betriebsanleitung
Istruzioni per l'uso
MSE-403
3. During the mounting or the
4. The tool shank diameter should
MARK :
empty positions. Use the supplied
protection plug.
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Garant:
BT
Validation : 24.07.18
dismounting of your cutting tools,
block the spindle axis with the
IMBUS profile on the back of the
spindle.
never have a difference of more than
0.4 mm compared to the clamping
diameter of collet
Example: clamping diameter 9.5 mm
=> Shank diameter 9.1 mm
minimum.
Never use the tool holder with
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email:
office@pcm.ch
Document :
MSE-403 Mode
d'emploi
Page : 2 de 4
Publicité
