SCS Sentinel WifiCam 720 Notice D'utilisation Et D'installation page 19

D6- Consult recorded videos :
You can add motion sensors, ref SAL0011, available on www. scs-laboutique.com :
To program a sensor :
1) Inser 3 batteries AAA LR03 1.5V in your sensor.
2) The switch of the sensor should be on OFF position.
3) Open the app, and make the following manipulations :
During ten seconds, put the switch of the
sensor on ON. The red light should be
turned on for 1 second.
Your sensor appears here. You can name it
by clicking on it.
EN
19