Orbit F3400 Guide D'installation Rapide

ORBITF3400
ALL-IN-ONE DATA INTERFACE
REMOTE STARTER / ALARM
WIRING / CONNECTION GUIDE
(20-PIN) SECONDARY CONNECTOR
(+) Foot Brake
(-) Parking lights
750
mA
750 (-) Trunk Release / AUX
mA
(-) Hand Brake
(-) Hood/Door
Bypass config. Purple/Yellow
Bypass config.
Bypass config.
Bypass config.
Bypass config.
750 mA MAXIMUM OUTPUT. Do not exceed the maximum current or permanent damage to the module
(6-PIN) POWER CONNECTOR
Ground Black
(+) Ignition Pink
(+) Starter Yellow
(6-PIN) BYPASS RELAY
(4-PIN) DATA-LINK ANTENNA
PROGRAMMING REMOTE TRANSMITTER(S)
STEP 1 STEP 2
Turn the Ignition
Turn the
Ignition
Press and hold
ON.
the valet switch
until the park-
ing lights turn
ON, the horn/
siren will chirp.
COPYRIGHT © 2014-2017, FORTIN AUTO RADIO INC ALL RIGHTS RESERVED MADE IN CANADA
Black In
Pink Out
Yellow/Black Out
Brown/White In
Pink/Black In
Green/White
Green/Red
White/Black Out
Lt.Blue
A20
will occur that will not be covered under warranty.
In
Out
Out
E6
D C B
Red White Blue
(5-PIN) CAN-BUS
STEP 3
Turn the
OFF. Ignition ON.
Press and release the valet switch
five time.
The parking lights will flash and the
horn/siren will chirp each time to
confirm.
x5
A1 (+)
In Yellow
Out Purple
Out Purple/White
Out Green
Out White
Out Orange
Out Orange/Black
Out Dk.Blue
(-) GWR / Programmable
In Red/Blue
Lt.Blue/Black
E1
Out White
Out Orange
In Red
I
J
H
Blue
Black
REMOTE STARTER PROGRAMMING LED
BYPASS PROGRAMMING BUTTON
(4-PIN) RS-232 DATA-LINK & FLASH-LINK UPDATER PORT
(4-PIN) ANTENNA
The system can learn up to a maxi-
mum of 4 transmitters.
Any transmitters can be stored in
more than 1 memory slot.
When a 5th transmitter is learned
the 1st remote is erased (FIFO).
x4
The LED will
turn ON
Press and re-
lease the brake
x1
(3-PIN) Shock Sensor
(2-PIN) Valet/Programming Button
Ignition
Bypass
(-) Lock
750
mA
(-) Unlock
750
mA
(-) Ignition
750
mA
(-) Start
750
mA
(-) Disarm
750
mA
(-) Horn/Siren
2 Amp
750
mA
Bypass config.
Bypass config.
(+) ParkLight/IGN2
/ACC/START
Programmable Output
(FUNCTION 2 & 31)
(+) ACC / IGN2
Programmable Output
(FUNCTION 2 & 31)
(+) 12V
CAN ACTIVITY
LED Blue
LED Yellow IGNITION ON
LED Red BYPASS DATA
CUT LOOP FOR
AUTOMATIC
TRANSMISSION
MODE.
STEP 4
Press and
release the
brake pedal
four times.
On each Transmitter press
and release the
The LED
then press and release the
will flash
pedal once. rapidly.
button. The LED will stop
flashing confirming programming.
QUICK
INSTALLATION GUIDE
GUIDE # 33041
G
White
F
Black
REMOTE
STARTER
FIRMWARE
VERSION
1. [21]
A
ET PLUS
E
White
STEP 5 STEP 6
Turn the Ignition
OFF to exit
button
programming.
REV.:20170323